• guaranteed measuring accuracy of the flowmeters calibration service factory test stand

KRAL Calibration Service.

The best possible measurement precision of your KRAL flowmeters.

Each KRAL flowmeter is tested and calibrated on our factory test stand.  Two types of calibrations are available. First, there is the KRAL factory calibration method, which is our standard, and the alternative is calibration in compliance with the internationally acknowledged standard ISO/IEC 17025. 

ILAC, International Association of Accreditation Bodies in the Field of Laboratory Accreditation, is an organisation whose members represent over 70 countries and regional organisations. The worldwide accreditation bodies have signed an agreement (ILAC Mutual Recognition Arrangement MRA) which creates an international framework and improves the acceptance of products and services across national borders. This means that products and services do not have to be re-tested each time a new market is entered. ILAC's aim is to implement the principle of "once tested, accepted everywhere". The combined ILAC MRA mark makes the international recognition status transparent. KRAL is entitled to use the mark on accredited calibration certificates.

KRAL factory calibration features the following services:

  • Standard calibration at KRAL.
  • 7-point linearization.
  • Specification of the average K-factor based on the measured upper 5 points.
  • Higher flexibility, for example, by adding further measurement points.

Calibration according to ISO/IEC 17025 features the following services:

  • Accredited calibration upon request only.
  • 7-point linearization.
  • Specification of the average K-factor based on the measured upper 5 points.
  • Traceability to national standards.
  • Specification of measurement uncertainty of national standard to test unit.

Increase the service life of your KRAL flowmeters
with regular recalibration.

KRAL recommends recalibration after one year in operation to ensure technical function and accuracy.

During recalibration, the meter is calibrated (choice of KRAL factory or ISO/IEC 17025 - calibration according to customer requirements).

A description of the process for dealing with complaints can be requested at kalibrierstelle@kral-nospam.at and will be made available to you if required.

 

Back